Fe3O4/Mg(OH)2复合材料的制备及形貌控制

通过种子沉积法制备出Fe_3O_4/Mg(OH)_2复合材料并进行XRD、SEM测试分析。探究了氨水的浓度与加入速度、搅拌速度及等因素对磁性复合材料形貌的影响。氨水浓度与注入速度的降低,对氢氧化镁基体形貌的影响是相同的,但要使合成磁性复合材料形貌和四氧化三铁粒子在氢氧化镁中分散性均匀,应控制氨水浓度(ω=2.5%)或加入速度在一个合理的较低值。     

局部大地水准面精化系统软件的设计与实现

给出了局部大地水准面精化系统的总体结构以及各分系统的详细设计与实现方法,开发了旨在对相关重力测量数据实现自动化处理的局部大地水准面精化系统工具软件,并应用于某区域实际大地水准面的精确计算。实践证明,该系统能有效提高相关数据的处理效率,有助于局部大地水准面精化过程的规范化。     

天文(重力)水准的新手段及其计算方法

介绍当今确定天文大地垂偏差的新仪器－CCD自动天体测量仪和确定两点间高程异常差的新方法，该方法用单极坐标代替繁琐的双极坐标进行计算，讨论了天文重力水准的误差及垂线偏差非线性影响等问题，估计在不久的将来，用这一手段施测山区似大地水准面的精度可望达到厘米级。     

拉格朗日插值法在渔业资源评估上的应用

应用拉格朗日插值法拟合鱼类体长与体重之间的函数关系 ,使用计算机VB语言进行编写程序 ,与常用的线性回归法、Ricker法进行比较 ,得出体长与体重的关系式为Pn(x) =∑nk=0yklk(x)=∑nk=0(∏nj=0j≠kx-xjxk-xj)yk 。     

原子钟噪声的蒙特卡络模拟方法

讨论了原子钟噪声的蒙特卡络模拟方法．具体过程是：先产生模拟所需的正态分布随机数，从实际钟的阿仑方差估算出噪声电平，然后用１组递点函数产生高质量的模拟钟时差的随机序列．在对１台商品铯钟进行具体模拟后，给出了真实数据与模拟值的阿仑方差之问的相符程度，最后对实际问题进行了分析．     

地壳演化与成矿作用——以川滇地洼系“四层楼”铜矿床序列为例

提出川滇地洼系“四层楼”铜矿床序列的形成与陆壳演化的成生联系,是与本区陆壳由前地槽—地槽—地台—地洼演化各阶段与之相匹配的成矿作用的产物.与此同时,并总结了本区“四层楼”铜矿床序列的成矿作用具有明显的继承性、新生性、旋回性及层控性四大特点和多因复成矿床的成矿模式.     

An Atomic Force Microscopy study of the growth of calcite in the presence of sodium sulfate

In situ atomic force microscopy (AFM) has been used to compare the growth of pure calcite and the growth of calcite in the presence of sulfate ions from aqueous solutions at a constant value of supersaturation (S.I. = 0.89) with respect to calcite. The effect of sulfate ions on calcite growth rates is determined and a potential incorporation of sulfate ions is identified in the calcite during growth. Solutions supersaturated with respect to calcite with solution concentration ratio of one and a constant pH of 10.2, were prepared and sulfate was added as Na₂SO₄ aqueous solution. The solution composition was readjusted in order to keep the supersaturation and pH constant. PHREEQC was used to determine relevant solution concentrations. In situ AFM experiments of calcite growth were performed using a fluid cell and flowing solutions passed over a freshly cleaved calcite surface. Growth rates were determined from the closure of the rhombohedral etch pits induced by initial dissolution with pure water. The spreading rate of 2-dimensional nuclei was also measured. At low concentrations of sulfate (≤ 0.5 mM), no effect on the growth rate of the calcite was observed. At higher concentrations (2 to 3 mM) of sulfate, the growth rate increased, possibly because a higher concentration of calcium and carbonate was necessary to maintain the supersaturation constant. At much higher concentrations of additional sulfate (up to 60 mM) the growth rate of the calcite was substantially decreased, despite the fact that a further increase of calcium and carbonate was required. The morphology of 2-dimensional growth nuclei became increasingly elongated with increasing sulfate content. Measurements of step height showed that newly grown steps were approximately 1 Å higher when grown in high sulfate concentrations, compared to steps grown in sulfate-free solutions. At sulfate concentrations above 5 mM the growth mechanism changes from layer growth to surface roughening. These observations suggest that the new growth has incorporated sulfate into the calcite surface.     

The mitigation of the vibration effects caused by tunnel blasts in urban areas: a case study in Istanbul

Ground vibrations generated by commercial explosives in tunnel construction may cause structural damage in urban areas. Therefore, suppressing the vibration effects and mitigating the possible hazard after blasting is important. We present a new method of controlled blasting that is environmentally friendly, and easy to utilize for tunnel construction. Small charges in this method are detonated sequentially to produce minimum side effects. The efficiency of the charges may be increased based on the previously monitored shots. This method is utilized in a tunnel construction in Istanbul with five experimental shots. In these experiments, the duration and also the quantity of explosives were carefully controlled. We were able to obtain better results with short durations (480 ms) instead of long durations (9,000 ms) although the vibration levels defined as peak particle velocity (PPV) became bigger while the quantity of the explosive charge increased from 3.088 to 9.264 kg.     

Travel time based approach for the assessment of vulnerability of karst groundwater: the Transit Time Method

Karst aquifers represent important water resources in many parts of the world. Unfortunately, karst aquifers are characterised by high contamination risks. This paper presents a travel time based method for the estimation of karst groundwater vulnerability. It considers (1) physics-based lateral flow within the uppermost weathered zone (epikarst) in a limestone-dominated region and (2) high velocities of vertical infiltration at discrete infiltration points (e.g. sinkholes) or lines (e.g. dry valleys, faults). Consequently, the Transit Time Method honours the actual flow path within the unsaturated zone of a karst aquifer system. A test site in Northern Jordan was chosen for the demonstration of the assessment technique, i.e. the catchment area of the Qunayyah Spring north of the capital Amman. The results demonstrate that zones of highest vulnerability lie within valleys and nearby main fault zones. It also reveals that regions, categorised as protected areas by other methods due to thick unsaturated zones, contribute to a major degree to the total risk.     

库车坳陷大北地区下白垩统巴什基奇克组储层成因地质分挝

塔里木盆地库车坳陷大北地区白垩系巴什基奇克组储层以细一中粒岩屑砂岩为主夹少量长石岩屑砂岩,杂基为铁泥质和泥质(2%～10%).胶结物以方解石(3%～15%)为主.粘土矿物以伊利石、绿泥石和伊/蒙混层为主,不含高岭石,伊/蒙混层中的蒙皂石含量一般为(15～20)%;主要孔隙组合为残余原生粒问孔-溶蚀孔-微孔隙,占储集空间总量的(50～90)%,其次为构造缝-溶蚀孔,主要的孔隙类型为溶蚀孔和裂缝,总体属于低孔低渗-特低孔特低渗储层.综合分析认为:阶段性的前陆构造逆冲推覆作用对沉积旋回性、水体盐度变化及物源区距离变化的控制至关重要;构造活跃期扇三角洲前缘环境中形成的差分选中-粗砂岩、近源快速堆积造成的高岩屑含量、干旱成湖导致的高碳酸盐胶结和早成岩期相对深埋-后期持续快速深埋压实作用,是特低孔特低渗储层的主要成因;而较优质储层足构造平缓期辫状河三角洲前缘环境中形成的分选好的中-细砂岩、早期表生溶蚀及弱碳酸盐胶结作用、早期构造破裂的复合作用及其叠加效应的结果.